System requirements for the plus series
The following system requirements refer to SYMplus™ with plusCARE™. No technical support can be provided for older software versions as well as for operating systems older than Windows 10
Automatic transmission and manual transmission
speed range, this must be set up in two places in the software: Under F8 Setup > F4 System configuration > Presettings > mark
Error message: Traverse path exceeded in X / Y / Z
This is how it works ... Operating mode F8 Setup > F4 System configuration > F1 Presettings> Mark "Machine description" > F2 Modify
Tool change position PAL Turning
settings by mistake), you can do so: Operating mode F8 Setup > F4 System configuration > F1 Presettings > Mark "Operating mode
FANUC simulators: Reading in NC programmes with/without decimal point
). The file names are somewhat “cryptic”, e.g. the preset file for the FANUC 18i-TB (G-Code System A) in turning is called F18ADWX.INI
No solution found?
If you haven't found a solution, you can also write a support message.